Wagan 2544 Manuale Utente Scaricare il pdf (Pagina 9)

User’s Manual—Please read before using this equipment

Wagan and wagan.com are trademarks used by Wagan Corporation.

Follow instructions for a negative grounded system as indicated below:

Securely connect the positive (+) red clamp to the positive (POS,

P, +) terminal of the vehicle battery or the remote positive (+)

terminal if equipped.

Securely connect the negative (-) black clamp to the vehicle

chassis, engine block or a non-moving metal part of the vehicle

which is veriﬁed to be grounded. Do not clamp directly to

negative battery terminal, carburetor, fuel lines or sheet metal

body parts.

See jumpstarting step 7 to continue.

Follow instructions for a positive grounded system as indicated below:

Securely connect the negative (-) black clamp to the negative

(Neg, N, -) ungrounded terminal of the vehicle battery.

Securely connect the positive (+) red clamp to the vehicle chassis,

engine block or a non-moving metal part of the vehicle which is

veriﬁed to be grounded. Do not clamp directly to positive battery

terminal, carburetor, fuel lines or sheet metal body parts.

See jumpstarting step 7 to continue.

Set On/Off safety switch to “ON” after clamps are secure on battery

post.

Allow 2 or 3 minutes of charging time. It is recommended to have a

second person to assist holding the unit securely in place during the next

steps.

Turn on the vehicle to attempt to start the engine. If the vehicle does not

start after 4 to 5 seconds of engine cranking, then stop. Wait 3 to 4

minutes, and then try again. Repeat several times until the vehicle starts.

CAUTION: Excessive engine cranking can damage the vehicle starter

motor. If the engine turns but fails to start after several attempts, other

technical problems might be involved. Discontinue cranking the engine

•

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Nessun commento

Wagan 2544 Manuale Utente Pagina 9